Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
Remove and Replace Front pads, Lube all Caliper Moving Mechanism. Check for Front Brake Hydraulic system and Brake Rotors. Test Drive
Remove and replace air filter. Inspect and remove any debris obstructing the air intake system.
RYAN M. gave our service a 5 star review on 11/3/2025
Remove and Replace Rear pads, Lube all Caliper Moving Mechanism. Check for Brake Hydraulic system and Brake Rotors. Test Drive
BRAKE ROTOR REPLACEMENT
Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
Road test for power steering operation. Inspect system for leaks. Flush power steering lines, pump, rack and pinion, and or gear box. Install new power steering fluid. Road test vehicle.
Inspect hoses and clamps. Do pressure test cooling system. Drain and fill engine, radiator, heater core section and fill with new coolant. Bleed coolant system per oe recommended procedure, check thermostat and elec. cooling fan operation. Perform drive cycle and test drive.
Remove and Replace Front pads, Lube all Caliper Moving Mechanism. Check for Front Brake Hydraulic system and Brake Rotors. Test Drive
BRAKE ROTOR REPLACEMENT
TROY D. gave our service a 5 star review on 11/2/2025
NO CODES. NO VISUAL LEAK. CHECKED POWER AND GROUND TO A/C COMPRESSOR OK. APPLIED DIRECT POWER AND CLUTCH ENGAGES. EVAC SYSTEM AND RECOVERED 0.1LB. SPEC 1.63 LB. USED SNIFFER TOOL AND FOUND HIGH AND LOW SIDE SHREDDER VALVES LEAKING. RECOMMEND REPLACE AND RECHARGE AND MONITOR. IF RETURN NO DIAG FEE.
Service air conditioner. Visually inspect hoses, tubing, connections,drive belt, electric connection, compressor (pulley and clutch section), condenser, accumulator receiver and dryer, cooling fan and fan clutch. Check for contamination. Evacuate and recharge with reclaimed R-134. Test system performance. Check low and high side pressure. LOW SIDE: 35 PSI HIGH SIDE: 210 PSI CENTER VENT OUTLET TEMP: 43 DEG F
LONNIE R. gave our service a 5 star review on 9/25/2025
RESET REMINDER( ) REMINDER STICKER ( ) TEST DRIVE ( ) MILES
WHEEL LOCK (IF APPLICABLE) RESTORE ORIGINAL LOCATION.
TORQUE ALL LUG NUTS PER OEM SPEC (IF WHEELS REMOVED)
PERFORM WIPE DOWN ALL STAIN MARK (DOOR HANDLES, WINDOW SWITCH, STEERING WHEEL, OUTSIDE BODY)
CHECKED BATTERY OK, CHARGING OK, STARTER VOLT OK, IGN VOLT OK. FOUND CODE: P0725 – ENGINE SPEED. CHECKED CRANKSHAFT POSITION SENSOR LIVE DATA INDICATES SENSOR BAD. RECOMMEND CRANK AND CAM SENSOR AND MONITOR.
drain transmission fluid, inspect any debris in fluid, discoloration or abnomality. Refill trans fluid and test drive. check correct fluid level.
CRANKSHAFT POSITION SENSOR – Remove & Replace – 2.0L Eng
CAMSHAFT POSITION SENSOR – Remove & Replace
Lubricate and check chassis Change oil and oil filter. Check wiper blades Check all fluid levels and tire pressures. Check belts and hoses Check Front brake and check steering Preform basic safety inspection. APPROVED: BMW LL01; MB-APP 229.5; VW 502.00/505.00
DANIEL C. gave our service a 5 star review on 9/11/2025
ACCESSORY DRIVE BELT – INSPECT – w/Pick up Bed Power Outlet AIR CLEANER ELEMENT – REPLACE CABIN AIR FILTER – REPLACE SPARK PLUGS – REPLACE – w/Pick up Bed Power Outlet ENGINE OIL AND FILTER – REPLACE TIRE – ROTATE
FRONT REAR (IN PSI UNIT) INSPECT TIRES AND ADJUST/INFLATE TIRE PRESSURE
FOUND REAR BRAKE METAL TO METAL. RECOMMEND PAD AND ROTORS. FRONT BRAKE 6MM.
Remove and Replace Rear pads, Lube all Caliper Moving Mechanism. Check for Brake Hydraulic system and Brake Rotors. Test Drive
BRAKE ROTOR REPLACEMENT
Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
CARI B. gave our service a 5 star review on 7/4/2025
CUSTOMER REPLACED VALVE COVER, SPARK PLUGS AND STILL OIL PRESS LOW WARNING CAME ON AFTER 1 WK. TOP OFF OIL AND WARNING LIGHT WENT AWAY. VERIFY AND ADVISE. SLIGHT LEAK BY OIL PAN GASKET. REMOVED SPARK PLUG AND FOUND HEAVY OIL RESIDUE. PERFORM BOROSCOPE AND FOUND OIL BURNING INTERNAL CYLINDER. POSS VALVE SEAL OR PISTON RING SEAL.
ERIN C. gave our service a 5 star review on 4/22/2025
REMOVE RIGHT FRONT DOOR BELT MOLDING, OUTSIDE HANDLE, RIGHT SIDE MIRROR, LOWER BLACK MOLDING. REMOVE RIGHT REAR DOOR OUTSIDE HANDLE, BELT MOLDING, LOWER BLACK MOLDING.
SCAN ALL MODULES, PROVIDE REPORT AND RESET, AND PROVIDE SECOND REPORT ( )
TEST DRIVE FOR ADAS OPERATOIN ( ) MILES BY ( )
PRE-DELIVERY INSPECTION ( )
FRONT 35 REAR 35 (IN PSI UNIT) INSPECT TIRES AND ADJUST/INFLATE TIRE PRESSURE